AlarmNet 7845C Manual de usuario descargar pdf (Pagina 10)

The status channel (9th channel) identifies the type of message

0 = Diagnostic Messages

1 = Notification Message

2 = Not applicable to radio accounts

3 = Not applicable to radio accounts

4 = Not applicable to radio accounts

5 = Subscriber Trouble / Special Reports

6 = Status Message

7 = Alarm condition

8 = Alarm with low battery (old 7620 radio)

9 = Installer or network generated test message, Daily Test message

The previous eight channels indicate the message details:

 For System messages, each channel represents a unique condition

 For Subscriber Zone Conditions, each channel represents a zone:

High-Speed Message interpretation:

Below are explanations of high-speed messages that may be sent by an AlarmNet radio, the AlarmNet network,

or the Ademco receiver regarding AlarmNet. These messages are categorized according to the value in the

status channel, which determines the type of report. Some types of messages (generally those with status

channel “0”) do not use the first eight channels to indicate zones. These messages have to be identified by a

unique character in a particular channel

Note:

 The letters ‘cccc’ are used to represent the customer subscriber ID number (radio account number).

 All messages apply to all types of radios (AlarmNet–A, –M, and –C), except where noted.

 The numbers “0000” and “0001” in the location of the subscriber account are actual account numbers

that identify messages pertaining to the primary and secondary AlarmNet C/S transceivers. Messages

for these accounts apply to central station’s using AlarmNet-A and AlarmNet-M RF transceivers only.

 Other lowercase letters are used to represent different codes or characters that have various meanings in

certain messages.

 The “Key Indicator” is a specific character in a particular channel position that can be used to identify a

specific message.

 It is important to read the definitions contained in the Glossary to determine meanings and causes of

certain expressions for conditions used in this manual.

AlarmNet Messages Page 10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

Sin comentarios

AlarmNet 7845C Manual de usuario Pagina 10